Effects of MgO buffer annealing on optical and electrical quality of P-MBE grown ZnO films on c-sapphire

Open

A. Setiawan, T. Yao

2016 IOP Conference Series: Materials Science and Engineering Vol. 128 Issue 1 Conference paper Cited by 1 SDG 17SDG 16 Quartile

Abstract

Zinc oxide (ZnO) has been attracting much attention because of its potential applications in photonic and optoelectronic devices. In this present study, we investigated the effect of MgO buffer annealing on the optical and electrical quality of P-MBE grown ZnO films on c-sapphire with MgO buffer layer. The optical quality was observed by low-temperature PL (photoluminescence) measurement in the near band edge emission region measured at 10K and at 77K. The emission line located at 3.368eV dominates the spectrum in both samples (ZnO with and without MgO buffer annealing) at 10K and 77K. This emission can be divided into two peaks, 3.367eV and 3.363eV and assigned as I2 (ionized donor bound excitons emission) and I4 (Hydrogen donor related emission), respectively. The relative intensity of these donor bound exactions to free exaction emission of the sample without MgO buffer annealing is greater than that of the sample with MgO buffer annealing. Comparison of the PL spectra of ZnO with and without annealing revealed that the intensity of free exciton emission from the sample with MgO buffer annealing is twice of that from the sample without annealing. We also found that the intensity of deep-level broad emission is reduced by about 1/3 by MgO-buffer annealing. Hence, the decrease of deep level emission intensity and the increase of free exciton emission intensity by annealing of MgO buffer corresponds to the reduction of defects of the ZnO film. The PL properties also suggest that there are fewer nonradiative recombination centers in ZnO layers with MgO buffer annealing than those in ZnO layers grown without MgO buffer annealing. The electrical quality was measured by room temperature Hall measurements. We found that the samples have a background n-type carrier concentration. The ZnO samples with MgO buffer annealing has a carrier concentration of 1.17×1017 cm-3 and Hall mobility of 120 cm2/V.s, while the ZnO sample without MgO buffer annealing has a carrier concentration of 2.63 × 1016 cm-3 and Hall mobility of 105 cm2/V.s. The improvement of electron mobility of ZnO films by MgO buffer annealing is due to a decrease in dislocation density. We conclude that annealing of MgO buffer layer increases the optical and electrical quality of the ZnO films. These results agree with the structural quality as observed by HRXRD. © Published under licence by IOP Publishing Ltd.

Affiliations

Department of Mechanical Engineering Education, Universitas Pendidikan Indonesia, Jl. Dr. Setiabudhi 229, Bandung, 40154, Indonesia; Center for Interdisciplinary Research, Tohoku University, Aramaki aza Aoba 6-3, Aoba-ku, Sendai, 980-8578, Japan

Research at a Glance

Premium content — register to unlock

Research at a Glance

Register to unlock

Topics & SDG Alignment

Premium content — register to unlock

Topics & SDG Alignment

Register to unlock

Collaboration

Premium content — register to unlock

Collaboration

Register to unlock

Author Profile (Selected)

Premium content — register to unlock

Author Profile (Selected)

Register to unlock

References Overview

Premium content — register to unlock

References Overview

Register to unlock

Journal & Source

Premium content — register to unlock

Journal & Source

Register to unlock

Metadata & Integrity

Premium content — register to unlock

Metadata & Integrity

Register to unlock